Eaton i-onEX Series - Page 53

i-on40 & i-onEX Range 4. Administration
Page 47
If you are a Normal User:
6. Press .


7. Press  until the display shows:


8. Press .
Note: If you have a prox tag allocated to you
then the screen will display “Delete
Prox Tag?”. See page 51.


9. Hold the prox tag up to the
keypad.
The keypad gives a double “beep”
confirmation tone. The keypad
display shows:
The control unit has learned the
identity of the tag and linked it with
your access code.


followed by:


You cannot register more than one tag per user. If you present a tag that
the control unit has already registered to another user then you will hear a
single low tone, the display will show a message that the tag is already in
use and will then revert to asking you to present the tag.
If you do not wish to register a tag for the user then press .
If you have a proximity tag and want to know who it belongs to then use the
Test - Prox Tag menu option, see page 57 .
Remote Controls and Two-way Key Fobs
No user can change any other user’s remote control or two-way keyfob. (A
Master User or Admin User can register a remote control or two-way
keyfob for a new user when they first add the user to the system, see page
52.) Any user except a “Duress”, “Guard” or “Set Only” user can register a
remote control or two-way keyfob for themselves as follows:
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).

