Eaton i-onEX Series - Page 92

4. Administration i-on40 & i-onEX Range
Page 86
addition, you can program the
output to come on and go off at
fixed times (see the next section).
“No”. The output goes on when a
user turns it on, but then goes off
again after a set time. You can
program the length of time the
output remains on.
15. Press  or  to select the option
you wish to use.
For example:


16. Press  to confirm your choice.
The keypad gives a double “beep”
confirmation tone. The keypad
display shows:


To Program Duration Times for non-Latched Outputs
First make sure that the output you wish to use is programmed as
Latched=No (see steps 1 to 16 starting on page 84).
17. Press  until the display shows:


18. Press .
The display shows the length of
time the output will stay turned on
(in seconds).


19. Key in the number of seconds that you
want the output to stay on. The
maximum is 999s.


20. Press .
The keypad gives a double “beep”
confirmation tone. The keypad
display shows:


25. Press  to leave the menu.
Note: You can switch the output on and off from the Menu by selecting
Outputs On/Off (see page 105).