Eaton PDI WaveStar TFA Static Transfer Switch Installation and Operation Manual P-164001113—Rev 01 29
Figure 15. Power Bus Connections
44..22..77 CCoonnttrrooll WWiirriinngg
All control wiring to and from the TFA STS should be rated at minimum 10A and cable insulation should be
rated for 600VAC, unless otherwise specified on the drawings. Control wire connections are only required for
some options.
44..22..88 PPrriimmaarryy aanndd SSeeccoonnddaarryy SSyysstteemm CCaabblliinngg
Left- and right-side panels allow cabling to PDU(s) in primary and secondary systems. See Figure 1, Figure 2,
and Figure 20 for panel locations.
44..33 OOuuttlliinnee DDrraawwiinnggss
The following five (5) pages have outline drawings for TFA STS 250-600A units with Bottom Cable Landing
Compartments. Submittal drawings are also available from your Eaton sales representative for units with Top
Cable Landing Compartments.
Installation TFA STS 250-600A Models
To Next Page
Loading...
