Eaton Power Xpert 9395P - Figure 3-6. FI-UPM Cabinet Center of Gravity; Inspecting and Unpacking the FI-UPM Cabinet

FIELD INSTALLED UPM INSTALLATION PLAN AND UNPACKING
Power Xpert 9395P Field Installed UPM Mechanical Installation Manual S P-164000503 Rev 1
3-6
468
[18.4]
830
[32.7]
1800
[74.0]
918
[36.1]
736
[29.0]
290
[11.4]
CG
CG
Dimensions are in millimeters [inches].
Figure 3‐6. FI-UPM Cabinet Center of Gravity
3.3 Inspecting and Unpacking the FI-UPM Cabinet
The FI-UPM cabinet is palleted separately for shipping. The cabinet is shipped bolted
to a wooden pallet and protected with outer protective packaging material (see
Figure 3‐7).
W A R N I N G
The FI-UPM cabinet is heavy (see Table 3‐1 on page 3-2). If unpacking and unloading instructions are not
closely followed, the cabinet may tip and cause serious injury.
A V E R T I S S E M E N T !
Les sections de l’onduleur sont lourdes (voir le Table 3‐1). Suivre attentivement les instructions de
déchargement et de déballage pour éviter de renverser les armoires, ce qui pourrait causer de graves
blessures.
1. Carefully inspect the outer packaging for evidence of damage during transit.
C A U T I O N
Do not install a damaged cabinet. Report any damage to the carrier and contact an Eaton service
representative immediately.
A T T E N T I O N !
Ne pas installer une armoire endommagée. Signaler les dommages au transporteur et communiquer avec un
représentant du service Eaton immédiatement.