EasyManua.ls Logo

Eaton Powerware 9910-E64 - Page 19

Eaton Powerware 9910-E64
39 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Powerware Power Protection Handbook for IBM 9910 International System i and System p Applications
18
P16 Technical Specifications*
Electrical Input
Nominal Voltage 230 Vac
Input Voltage Ranges 150–288V (without using batteries)
Input Power Factor >0.95 typical
Frequency 50/60 Hz, auto-sensing
Frequency Range 46–65 Hz
Electrical Output
On Utility Voltage Regulation ±3% of nominal
On Battery Voltage Regulation ±3% of nominal
Efficiency 89–92% depending on load
Frequency Regulation ±3 Hz online; ±1 Hz on battery
Load Crest Factor 3 to 1 ratio
Communications
Communication Port Relay port standard; optional X-Slot cards available
Communication Cable 6-ft AS/400 communication cable included
Battery
UPS Internal Battery Type 9 Ah, sealed, maintenance-free lead-acid
UPS Internal Battery Type 9 Ah, sealed, maintenance-free lead-acid
Battery Runtime See Battery Runtime Chart
Battery Replacement Hot-swappable UPS internal batteries and external batteries modules
Recharge Time <2 hours from complete discharge to 80% capacity at nominal line conditions
Start-On-Battery Allows start of UPS without utility input
General
Topology True online, double-conversion
Diagnostics Full system self-test on power up
UPS Bypass Automatic on overload or UPS failure
Dimensions and Weight See Model Guide
Environmental and Safety
Ambient Operating Temperature 0°C to 40°C (32°F to 104°F) 0°C to 25°C (32°F to 77°F)
Heat Dissipation 645 BTU/hr maximum
Leakage Current <0.6 mA typical
Storage Temperature 0°C to 25°C (32°F to 77°F)
Relative Humidity 0% to 90% noncondensing
Audible Noise <45 dBA typical
Safety Markings CSA, VDE, CE, S, D, N, FI, B NOM, R
EMC Compliance FCC Class B and VCCI Class II, 3000 FCC Class A
Surge Suppression IEEE/ANSI C62.41 Category B (formerly 587)
REPO Port Meets NEC code 645-11 intent and UL requirements
Network Transient Protector In and out jack for models only or 10BaseT network cable protection. UL497A tested
* Due to continuing product improvement programs, specifications subject to change without notice.

Related product manuals