Eaton PowerXL DC1 - 5.2 Setting parameters

5 Parameters
5.2 Setting parameters
DC1 variable frequency drive 12/13 MN04020003Z-EN www.eaton.com 95
5.2 Setting parameters
5.2.1 Operating unit
The following table shows a good example of the general execution for
selecting and setting parameters.
5.2.2 drivesConnect
A connection to the computer can be established by using
a DX-CBL-PC-1M5 / DX-COM-PCKIT connection cable or
a DX-COM-STICK Bluetooth stick. The drivesConnect program can be used
to configure the variable frequency drive's parameters using a computer.
5.2.3 Field bus/SmartWire DT
A DC1 variable frequency drive's parameters can be configured via a field
bus orSmartWire-DT.
￫
The flashing digit on the right indicates that the value being
displayed can be changed with the arrow keys (Up ▲ or Down ▼).
Sequence Commands View Description
0 Stop state: The variable frequency drive is ready for
operation.
1
Hold down the OK button for about two seconds.
Parameter P-01 will be displayed (the digit on the right,
"1," will flash)
Press OK button
The display will switch to H 50.0 (= 50 Hz), the digit on
the right, "0," will flash.
The value can be confirmed and automatically stored by
pressing the OK pushbutton. The display will jump back
to the parameter name (P-01).
2
The numerical first value is always shown from the
selected main menu.
￫
Press the OK button to activate and store changes and values.
￫
For more information, please refer to manual MN040003EN,
"drivesConnect ·
Parameter Configuration Software for
PowerXL™ Variable Frequency Drives"
￫
For more information, please refer to chapters 7 and 8 and to
manual MN04012009Z-EN.