Need help?Do you have a question about the Eaton DC1-124D1FN-A20N and is the answer not in the manual?
Official manual for the Eaton DC1 Frequency Inverter.
Warning about high voltage hazards and necessary precautions.
Essential safety steps before starting inverter installation.
Details the inverter's technical specifications and rating data.
Guidance on selecting the correct frequency inverter based on motor and system requirements.
Explanation of the information found on the device's nameplate.
Details mains connection, voltage, frequency, and network configurations.
Guidelines for ensuring electromagnetic compatibility in system installations.
Explanation of the information found on the device's nameplate.
Guidance on selecting the correct frequency inverter based on motor and system requirements.
Details the inverter's technical specifications and rating data.
Defines intended industrial applications and restrictions for the DC1 inverter.
Recommended maintenance procedures and intervals for the DC1 inverter.
Covers fuses, cable cross-sections, RCDs, and mains contactor safety.
Explains how to connect the frequency inverter to the AC supply system.
Guidelines for ensuring electromagnetic compatibility in system installations.
Details mains connection, voltage, frequency, and network configurations.
Details fuse selection and cable cross-sections based on rated mains current.
Explains the suitability and type of RCDs required for frequency inverters.
DC1 Inverter Motor Selection Guidelines
Guidelines for connecting motors in hazardous locations, including ATEX regulations.
Recommendations for selecting motors and suitable applications for DC1 inverters.
Measures for ensuring electromagnetic compatibility during installation.
Details protective earth connections for the control panel and system.
Details the terminals for mains voltage, DC supplies, motor, and braking resistance.
Details the factory-set functions and electrical connection data for control terminals.
Explains the legally required protective earth connection for the inverter.
General instructions and precautions for wiring the frequency inverter.
A checklist to ensure all requirements are met before placing the frequency converter into operation.
Important safety warnings and precautions during operation and commissioning.
Guidance on starting the inverter using control signal terminals with default settings.
Explains the internal monitoring functions and how error messages are displayed.
Details the stored error messages and how to access them via parameters.
Table of failure codes, possible causes, and corrective measures for DC1 inverters.
Provides an example of how to select and set parameters using the operating unit.
Explains how to configure digital and analog inputs based on parameter P-15 and P-12.
Instructions for entering motor specifications from the rating plate for optimal operation.
Details the digital and analog output capabilities and their configurations.
Configures the inverter's behavior for automatic restart after errors or trips.
Details various braking functions: DC braking, regenerative braking, and mechanical braking.
Describes regenerative braking, DC link voltage increase, and brake chopper activation.
Introduction to Modbus RTU as a master-slave polled bus system for data transfer.
Maps register addresses for mode parameter, input, and output process data.
Lists and explains the Modbus parameters for configuring the DC1 frequency inverter.
Lists manufacturer-specific objects that correspond to the inverter's parameters.
Defines the bits used in the control word for commands like Stop, FWD, REV, and Reset.
Lists failure codes, display values, and descriptions for inverter errors.
Guidance on selecting cable cross-sections and protection fuses for compliance with standards.
To Next Page
General