Eaton DC1-124D1FN-A20N - Parameter selection

5 Error messages
5.1 Introduction
90 DC1 Frequency Inverter 10/12 MN04020003Z-EN www.eaton.com
The example below shows how to access the fault log.
Indicator Explanation
Operating state Stop
Press OK button
The parameter that was last accessed will be shown.
The last digit on the display will flash.
Use the ▲ (Up) or ▼ (Down) arrow buttons to select parameter P-13 and
confirm your selection by pressing the OK pushbutton.
Last error message.
Example: P-dEf (Parameter default = Default setting loaded).
Use the arrow button ▲ (Up) to go to the next error message.
Second most recent error message:
Example: V-Volt (“Voltage too low” message). The dot on the right
will flash.
The third most recent error message will be shown after pressing
the ▲ arrow button (Up).
Example: E-trip (external error message).
The two dots on the right will flash.
The oldest error message will be shown after you press the ▲ arrow
button (Up) once more.
Example: V-Volt (“Voltage too low” message)
The three dots on the right will flash.