6 Parameters
6.1 Operating unit
106 DC1 Frequency Inverter 10/12 MN04020003Z-EN www.eaton.com
6.1.4 Parameter selection
Parameter P-14 is used to select between a limited range of parameters
(P-14 = 0) or all parameters (P-14 = P-37, WE = 101).
Parameter P-37 is used to change the access code used to access all the
parameters. Once you confirm parameter P-37, the extended parameters will
be locked.
You can use parameter P-38 to block access to all parameters, with the
exception of parameter P-14 (read-only).
￫
Press the OK button to activate and store changes and values.
To Next Page
Loading...
