3 Installation
3.2 Mounting
DC1 Frequency Inverter 10/12 MN04020003Z-EN www.eaton.com 57
Figure 32: Fixing to the mounting rail
Dismantling from mounting rails
To remove the device, push down the spring-loaded clip. A cutout
marked on the lower edge of the device is provided for this purpose.
A flat-bladed screwdriver (blade width 5 mm) is recommended for
pushing down the clip.
Figure 33: Dismantling from mounting rails
2
1
VAR
EMC
VAR
EMC
To Next Page
Loading...
