Eaton PowerXL DM1 Series - Page 59

57
Step 5 - Standard application
POWERXL DM1 SERIES ADJUSTABLE FREQUENCY DRIVES PUB53696—August 2020 www.eaton.com
Table 21. System (Cont.).
P13.1 - Basic settings.
P13.1.1
Language
ID 340
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
0
Options:
0 = English;
1 = English; or
2 = English.
Description:
This parameter offers the ability to control the frequency converter through the keypad in the language of your choice. Currently
available language is English only.
P13.1.2
a
Application
ID 142
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
N.A.
Options:
0 = Standard;;
1 = Pump;
2 = Fan; or
3 = Multi-purpose.
Description:
This parameter sets the active application if multiple applications have been loaded.
P13.1.3
a
Parameter sets
ID 619
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
N.A.
Options:
0 = No;
1 = Reload defaults;
2 = Reload set 1;
3 = Reload set 2;
4 = Store set 1;
5 = Store set 2;
6 = Reset; or
7 = Reload defaults VM.
Description:
This parameter allows you to reload the factory default parameter values, and to store and load two customized parameter sets.
P13.1.4
Up to keypad
ID 620
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
N.A.
Options:
0 = No; or
1 = Yes (all parameters).
Description:
This function uploads all existing parameter groups to the keypad.
P13.1.5
a
Down from keypad
ID 621
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
N.A.
Options:
0 = No;
1 = All parameters;
2 = All, no motor; or
3 = Application parameters.
Description:
This function downloads one or all parameter groups from the keypad to the drive.
P13.1.7
Parameter lock PIN
ID 624
Minimum value:
0
Maximum value:
9,999
Default value:
0
Description:
The application selection can be protected against unauthorized changes with the password function. When the password function is
enabled, the user will be prompted to enter a password before application changes, parameter value changes, or password changes.
By default, the password function is not in use. If you want to activate the password, change the value of this parameter to any number
between 1 and 9,999.
To deactivate the password, reset the parameter value to 0.
.