Why is my Eaton UPS operating on battery power?
Your Eaton UPS might be operating on battery power because the circuit breaker 12 has been tripped by an overload on the UPS output. To resolve this, disconnect excess equipment and reset the circuit breaker 12 by pressing the corresponding button.
What to do if green button 11 flashes frequently and audio alarm is continuous on my Eaton Protection Station 650 UPS?
If the green button 11 flashes frequently and the audio alarm is continuous on your Eaton UPS, it indicates that the UPS battery backup outlets 8 are overloaded. Disconnect excess equipment connected to the battery backup outlets 8 to resolve this issue.
What to do if green button 11 flashes frequently and audio alarm beeps every 5 seconds on my Eaton Protection Station 650 UPS?
If the green button 11 flashes frequently and the audio alarm beeps every 5 seconds on your Eaton UPS, it means that the UPS frequently operates on battery power because the AC power source is of poor quality. To resolve this, have the electrical installation checked by a professional or use another wall outlet.
What does it mean if red LED 10 is ON on my Eaton Protection Station 650 UPS?
If the red LED 10 is ON on your Eaton UPS, it means that the battery has reached the end of its service life. You should have the battery replaced.
What to do if the connected devices are not supplied when AC power fails on my Eaton Protection Station 650 UPS?
If the connected devices are not supplied when AC power fails on your Eaton UPS, it is probably because the devices are not connected to the battery backup outlets. Connect the devices to the battery backup outlets.
Why are the filtered outlets not supplied on my Eaton Protection Station 650?
The filtered outlets on your Eaton UPS might not be supplied because either the wall outlet is not supplied, or the circuit breaker 12 has been tripped by an overload on the UPS output. First, ensure that the wall outlet is receiving power. If it is, disconnect excess equipment and reset the circuit breaker 12 by pressing the corresponding button.
Connect UPS to AC power, plug critical equipment into battery backup and filtered outlets, and optional fax/modem/COM connections.
Explains outlet types, LED indicators, ON/OFF button, battery charge process, and AC disturbance handling.
Details how EcoControl outlets work with Master outlets to save energy by deactivating peripherals.
Configure EcoControl sensitivity (High/Low) via software based on main load consumption.
Warning about polarity during battery connection; replace only with qualified personnel and approved batteries.
Customize AC input voltage sensitivity to prevent frequent UPS battery switching.
Configure UPS audio alarm modes (normal or silent) during battery operation.
Details UPS power, voltage, frequency, current, leakage, input protection, and transfer time.
Details surge protection performance for AC input sources according to IEC 61643-1.
Specifies dielectric isolation test voltages and temporary overvoltage tolerance values.
To Next Page
General