XS series operating manual
XS user manual v0.55 - 125 -
BEEP ON/OFF
This command is attached to the configuration function and controls the beep signal when
the measurement result is false.
It is not possible to stop the beep signal completely.
For instance : CONF:DISP OFF
DISP(DISPlay) ON/OFF
This command is attached to the configuration function and controls the display mode.
For instance : CONF:DISP OFF
CAD (CApaDet) ON / OFF
This command is attached to the configuration of the SXS16 hipot function (hipot 10VA). It
activates/deactivates the detection of capacitive samples.
Ex : HIP:CAD ON
[expert]
EXP(EXPert) ON / OFF
Set the EXPERT mode ON or OFF
[expert]
M335 ON / OFF
Set the mode power in accordance with the standards 60335 et 60204.
[expert]
CTH (CapaTH) <NR1>
This command sets the capacitive value threshold, in nF, to detect, when the detection of
capacitive samples is activated.
MOD (MODe) AUT/MAN
This command is attached to the setup function. It switches the mode AUTO and
MANUAL of the sequence function (only with the family units of SMG and FMG).
SBS (Step By Step) ON/OFF
This command takes part of sequence function of the SMG and FMG.
It fixes on the way of the test results are send back to the controller (RS232, IEEE).
In ON mode, the result of every steps of test is transmitted as soon as available, without
any request before (no MEAS?).
In OFF mode, all the results are transmitted together at the end of the sequence in answer
to the command MEAS?
IMPORTANT : After power on the mode SBS is automatically set with OFF value.
TIM(TIMe) AUT/FAIL/UDIV2
Select the temporization mode. AUT for automatic, FAIL for default and UDIV2 for U
divided by 2.
The UDIV2 mode concerns the hipot function.
The FAIL mode concerns the ground continuity function and the hipot 500VA function
only.
FILT(FILTer) NOR/CAP/RHT
Enables the normal or the capacitor or the Real Hold Time measurement modes.
For instance : CONF:FILT CAP
To Next Page
Loading...
