Need help?Do you have a question about the Eaton Sefelec DXS500 and is the answer not in the manual?
General| Brand | Eaton |
|---|---|
| Model | Sefelec DXS500 |
| Category | Test Equipment |
| Language | English |
Limits and conditions for ground continuity measurements with specific accessories.
Limits and conditions for Hipot tests with specific accessories.
Limits and conditions for insulation measurements with specific accessories.
Explains breakdown detection methods for the 10VA model.
Explains how the unit detects breakdowns, including current variation modes.
Describes the breakdown detection modes for the 500VA Hipot test.
Details for performing insulation resistance measurements at 500V.
Explains the function of each key on the front panel.
Essential steps and warnings before installing the unit.
Guides on connecting specimens for insulation and Hipot tests.
Steps to set up a password for parameter access and security levels.
Details on connecting and using remote trigger signals.
How to configure parameters for insulation resistance tests.
Configuring voltage, hold time, rise/fall times for Hipot tests.
Configuring current, voltage, and resistance thresholds.
Details on the PLC interface for unit control and data exchange.
Steps to take when the unit does not respond to commands.
Troubleshooting steps for when the unit locks up in remote mode.
Benefits and disadvantages of performing dielectric tests with AC voltage.
Wiring instructions for safety loop, lamps, and test result contacts.
To Next Page