Eaton SEFELEC 506-H User Manual

SEFELEC 5X Series
50-C
56-H
56-D
56-S
506-H
506-D
506-S
1000-M
PENT6833
version 1.06 - July 2020
User Manual

Eaton SEFELEC 506-H Specifications

General

Brand	Eaton
Model	SEFELEC 506-H
Category	Test Equipment
Language	English

Summary

1.3. Warning and Safety Instructions

Safety Instructions Before and After Use

Covers pre-use checks (cords, vents) and post-use actions (power off, disconnect).

3.6. Measurement Specifications

Output Voltage and Current

Fault Detection and Time Delay

Insulation Resistance Measurement

Measurement Specifications and Ranges

Measurement Thresholds and Time Delay

Ground Continuity Measurement

Current, Voltage, and Threshold Settings

4. Safety

Security and Safety Arrangements

Covers precautions for electrical work and safety arrangements like grounding and loops.

4.2.1. Safety Loops

4.3. Precautions of Use

5. Commissioning

5.4. Switching On the Power to the Device

6. Configuration of the Device

6.1. Language Selection

6.2. Display Settings

6.5. System Settings

Firmware Updates

Steps for updating main and function board firmware via USB.

6.6. Access Settings

6.7. Selection of the Type of Interface

6.8. Restoration of the Default Settings

6.9. Storage of Results

Backup and Restore Operations

7. Setting the Measurement of Insulation Resistance

8. Measurement of Insulation Resistance

Component Connection and Precautions

Safety precautions and guidelines for connecting components and performing measurements.

8.2. Precautions to be Observed During Measurement

9. Dielectric Strength Test Settings

Adjusting Test Parameters

Covers adjusting time, voltage, frequency, and fault detection modes.

10. Performing a Dielectric Strength Test

Connection and Measurement Precautions

Safety precautions for connecting components and performing dielectric tests.

10.2. Precautions to be Observed During Measurement

11. Multi-slope Dielectric Strength Tests

Sequence Setup and Execution

Connecting components and precautions for multi-slope dielectric strength tests.

12. Setting the Measurement of Ground Continuity

Adjusting Measurement Parameters

Covers adjusting time, current, and comparison thresholds for ground continuity.

13. Ground Continuity Resistance Measurement

Connection and Precautions

Safety precautions for connecting components and performing ground continuity tests.

13.4. The Following Error Messages

14. Sequence Mode

Functions and Rules

14.2. Execution of a Sequence

15. PLC Interface (Programmable Logic Controller)

15.5. Measurement-Discharge Cycle

16. IEEE488-2 (GPIB) Interface

17. Ethernet Interface

Cyber Security Recommendations

Recommendations for securing the SEFELEC 5x range devices against cyber threats.

17.1.1. Asset Management

17.1.2. Risk Assessment

17.1.3. Physical Security

17.1.4. Account Management

17.1.5. Network Security

17.2. First Time Connection - White List

17.5. Setting of the Ethernet Connection on the Device

DHCP, IP Address, and Network Mask

18. RS232C Interface

19.4. Insulation Resistance Measurement

Precautions and Specific Measurements

19.5. Dielectric Strength Tests

Test Voltage Selection and Modes

19.6. Ground Continuity Measurement

Current, Voltage, Test Time, and Precautions

20.1.1. C5 Safety Connector

21. Care, Maintenance and Calibration

Maintenance and Calibration Procedures