Need help?Do you have a question about the Eaton Sefelec SXS500 and is the answer not in the manual?
General| Brand | Eaton |
|---|---|
| Model | Sefelec SXS500 |
| Category | Test Equipment |
| Language | English |
Details output voltage characteristics, stability, ripple, and accuracy for the 50VA Hipot test.
Details the breakdown detection modes, including current variation (ΔI) and its settings.
Details output voltage characteristics, stability, ripple, and accuracy for the 500VA Hipot test.
Details output voltage characteristics, stability, ripple, and accuracy for the 10VA Hipot test.
Explains the IMAX current limit setting and monitoring for breakdown detection.
Details the 500V megohmmeter function, including measurement voltage, range, and accuracy.
Explains setting measurement thresholds (LOW/HIGH) for PASS/FAIL determination.
Explains setting measurement thresholds (LOW/HIGH) for PASS/FAIL determination.
Explains setting measurement thresholds (LOW/HIGH) for PASS/FAIL determination.
Specifies the measurement current range, frequency, and accuracy for ground continuity.
Explains setting measurement thresholds for good/bad determination in ground continuity.
Emphasizes using the unit by qualified personnel and following safety regulations.
Provides critical safety warnings for operating the XS series unit, especially regarding HV probes.
Details the connection procedure for specimens in Insulation and Hipot tests using probes.
Explains how to connect the specimen for ground continuity measurements using probes.
Guides on how to set parameters for insulation resistance measurements.
Explains how to select the measurement voltage for insulation resistance tests.
Details how to select HI-LIMIT and LO-LIMIT thresholds for PASS/FAIL determination.
To Next Page