XS series operating manual
XS user manual v0.55 - 83 -
Scroll the possible selection (HIPOT, MEGOHM, GROUND,PAUSE, POINT) with up and down
arrow keys, then ENTER
Fig 10.7
Parameter memory number selection
Select the memory number with the right arrow.
Fig 10.8
With the up and down arrow keys, increase or decrease the memory number (from 0 to 9). Validate
the function with its number memory by pressing on the ENTER key.
Then enter the function and its memory number with the ENTER key
Series of tests with manual control
By default, the proceeding of a sequence is automatic. For instance, in the case of a sequence
including the following lines :
LINE 1 : MEGOHM 3
LINE 2 : HIPOT 4
The hipot test will be carried out immediately after the insulation measurement without intervention of
the user.
It is possible to control the step from one function to the other by inserting a pause between the lines.
The sequence will be as follows:
To Next Page
Loading...