Need help?Do you have a question about the Eaton SEFELEC 1000-M and is the answer not in the manual?
General| Brand | Eaton |
|---|---|
| Model | SEFELEC 1000-M |
| Category | Test Equipment |
| Language | English |
Provides essential safety instructions before and after using the measurement devices.
Highlights dangers of electric shock and precautions for safe operation.
Describes safety measures like sectioning and double safety loops for equipment protection.
Explains the function and connection of the double safety loop system.
Discusses measures for optimizing safety, including signaling and locking systems.
Details how to set the test voltage for dielectric strength tests.
Allows choosing fault detection modes like Delta I, IMAX, or combined.
Covers adjustment of IMAX, IMIN, and Delta I thresholds for fault detection.
Guides on setting test time modes (Auto, Permanent) for ground continuity tests.
Details how to set the test current for ground continuity measurements.
Allows setting high and low thresholds for PASS/FAIL in continuity tests.
Lists essential precautions for accurate ground continuity resistance measurements.
Guides on how to start and run a defined measurement sequence.
Explains the PLC-controlled measurement and discharge cycle with diagrams.
Offers best practices for securing the device and network communications.
Lists critical precautions for accurate insulation resistance measurements.
Explains how to select the appropriate test voltage based on standards.
Covers selection of detection modes for identifying breakdowns.
Details how to select the appropriate current for ground continuity tests.
Explains the selection of open voltage for ground continuity measurements.
To Next Page