Need help?Do you have a question about the Eaton Sefelec DXS56 and is the answer not in the manual?
General| Brand | Eaton |
|---|---|
| Model | Sefelec DXS56 |
| Category | Test Equipment |
| Language | English |
Specific parameters for XS50/XS56 models during dielectric testing.
Details on output voltage, reading, accuracy, and short circuit current.
Configuration of ΔI, IMAX, IMIN, FIMAX thresholds.
Accuracy specifications for AC and DC current measurements.
Specific parameters for XS500/XS506 models during dielectric testing.
Details on output voltage, reading, accuracy, and short circuit current.
Explains breakdown detection methods including the ΔI mode.
Specific parameters for XS16 model during dielectric strength testing.
Explains the general methods for detecting breakdowns.
Setting the maximum current limit for tests.
Faster detection of maximum current limit.
Combines FIMAX and Delta I modes.
Combines IMAX and Delta I modes.
Direct current measurement and methods for indicating faults.
Controls test timing with MANUAL, DEFAULT, and AUTO modes.
Details for 500V megohmmeter functionality, including voltage and range.
Setting high and low limits for PASS/FAIL results.
Setting high and low thresholds for good/bad continuity.
Warning about qualified personnel and essential safety precautions.
Steps to power on the unit.
Critical safety precautions for operating the unit.
Setting high and low limits for PASS/FAIL results.
Lists common error messages like SAFETY LOOP, OVER-RANGE, etc.
Selecting breakdown detection modes (ΔI, IMAX, FIMAX, OFF).
Setting maximum (IMAX, FIMAX) and minimum (IMIN) current limits.
Using FIMAX+ΔI and IMAX+ΔI modes for advanced detection.
Enabling capacitive sample detection before tests (SXS16 only).
Selecting breakdown detection modes specifically for voltage ramps.
Adjusting IMAX and Delta I thresholds for voltage ramps.
Selecting breakdown detection modes for DC tests, including IMAX, ΔI, and OFF.
Information on annual calibration and available kits.
To Next Page