Eaton Sefelec SXS506 User Manual

SEFELEC REFERENCE PENT0438
Operating manual XS SERIES - English

Eaton Sefelec SXS506 Specifications

General

Brand	Eaton
Model	Sefelec SXS506
Category	Test Equipment
Language	English

Summary

WARRANTY

DIELECTRIC STRENGTH TEST 50VA (hipot 50VA test)

DIELECTRIC STRENGTH TEST 10VA

Breakdown detection

Details breakdown detection modes for 10VA tests.

Megohmmeter function (insulation resistance measurement)

500V megohmmeter function

Details the 500V megohmmeter capabilities.

1000V megohmmeter function (option XS26 or MXS1000)

Describes the 1000V megohmmeter function.

1500V megohmmeter function (SXS16)

Details the 1500V megohmmeter function for SXS16.

Ground continuity function

Unit configuration

Access control to the parameters

Password programming

Remote trigger mode

Interface selection

Sequence selection (Option 04)

EXPERT mode Activation

Insulation resistance measurement

Parameter setting

Covers setting parameters for insulation resistance tests.

Measurement voltage selection

Details how to select measurement voltage.

Measurement threshold selection

Explains setting PASS/FAIL thresholds.

Error messages

Dielectric strength test (hipot test)

Test voltage selection

Details how to select test voltage for Hipot tests.

IMIN and IMAX threshold adjustment

Delta I level adjustment

Parameter memorization

Explains saving and recalling Hipot test parameters.

Breakdown detection mode selection during the ramps

IMAX and delta I thresholds adjustment during the ramps

Ground continuity resistance measurement

Setting

Covers setting parameters for ground continuity tests.

Resistance threshold selection

Details setting resistance thresholds.

Timer operation

Covers timer functionality for continuity tests.

Sequence mode operation (SXS)

Measurement function setting

Explains how to access and set measurement functions.

Sequence setting

Details how to configure sequences of tests.

Function selection

Covers selecting functions within a sequence.

Parameter memory number selection

Explains selecting memory for sequence parameters.

Error messages for the Sequence mode

Input output Interfaces

Input-Output for Programmable Logic Controller Interface (PLC)

Details PLC interface functionality and specifications.

Connections

Describes physical connections for I/O interfaces.

Measurement discharge cycle

Explains the sequence of measurement and discharge.

PLC > RS Interface (Option 115-00)

Unit control

Details PLC control of the unit via RS interface.

0 -10 Volts analog input output (03 OPTION )

Change of the board setup

Explains the procedure for changing board setup.

IEEE-488 interface

ETHERNET Interface

Configuring the connexion on the unit

Details steps for configuring unit's Ethernet connection.

IP address

Explains how to set the unit's IP address.

Subnet address mask

Details setting the subnet address mask.

Error message(s)

RS232C interface

Safety interlock connector (C5)

Measurement I/O on the rear panel

Maintenance and calibration

MAINTENANCE

CALIBRATION

Annexes

Operation of the XS 4-wire option in XS hipot function

HV sensor connection recommendations

Nominal DC currents in the hipot function

Details nominal DC currents for Hipot function.

Trouble shooting the RS232 interface

No reaction from the XS unit when sending commands :

Troubleshooting steps for no response from the unit.

The unit goes in REMOTE mode and then hang up :

Troubleshooting steps for unit hanging in REMOTE mode.