Eaton SEFELEC 506-H - Declaration of Conformity; Qualification of Personnel; Exclusion of Liability

User manual SEFELEC 5x Series 13 v1.06
DECLARATION OF CONFORMITY
The SEFELEC 5x range measuring devices marketed by the EATON Corporation comply with
the requirements of:
European Directives
2014/35/EU
covering the safety of
electrical equipment intended to be used within cer-
tain voltage limits. (Low Voltage Directive)
2014/30/EU
covering Electromagnetic Compatibility (EMC)
Harmonized standards
EN 61010
-1:2010/A1:2019/AC:2019-04
IEC 61010
-2-034 Edition January 2017
Safety rules for electrical equipment for
measurement, control and laboratory use.
EN 61326
-1:2013
Electrical equipment for measurement, control
and laboratory
use - requirement relating to
EMC
A copy of the Declaration of Conformity can be found at the end of this manual.
QUALIFICATION OF PERSONNEL
This manual is intended for persons qualified for work on electrical devices and having received
prior training on the use of the device. The manual gives the information necessary for the prop-
er assembly and use of devices in the SEFELEC 5x range.
The operation manual and the corresponding technical documents must be studied and under-
stood before using the device and the instructions must be observed.
EXCLUSION OF LIABILITY
This documentation presents the devices in their standard version.
Despite thorough checking of the content of this document, we cannot exclude possible errors.
The manufacturer does not accept responsibility for inaccuracies or omissions.
In case of doubt or for technical questions contact your technical representative.