User manual SEFELEC 5x Series 92 v1.06
PERFORMING A DIELECTRIC STRENGTH TEST
CONNECTION OF THE COMPONENT TO BE MEASURED
WARNING
Danger of electric shock!
: The accessories must only be handled by qualified personnel.
Only use accessories with the device or devices for which they are intended. The
safety of the operator and the proper functioning of the device used depend on the
respect of this rule.
Do not try to modify an accessory; measurement accessories may contain imita-
tion and protection elements. It is forbidden to modify the accessories without
written agreement from SEFELEC-EATON.
If the device is used in conditions other than those specified in the manual of the
device, potential risks may occur for the safety of the user.
ALWAYS observe the safety rules relating to the use of High Voltage equipment.
Never touch the metal tip of an accessory connected to a device.
Do not use accessories that are in poor condition, incomplete or defective. Check
the integrity of the accessory before every use.
Respect the conditions of use specified in the instructions of the associated
measurement devices.
Do not use an accessory in the place of another, just because it looks the same.
Each accessory is designed for a specific use and in strict association with a
measurement device.
More than one person should never use the same measurement accessories at the
same time.
To Next Page
Loading...
