XS series operating manual
XS user manual v0.55 - 68 -
Fig 8.17
For hipot tests under capacitive specimens , set FILTER : CAPACITOR in the menu unit
configuration
Configuration of the minimum capacity value to detect
Warning
This line only concerns SXS16 units
Fig 8.18
This line allows the user to raise the minimum capacity value to detect when the capacitive sample
detection is activated. This threshold can be configured from 5nF to 10nF by 1nF steps, and from
10nF to 1000nF by 10nF steps.
Dielectric strength test ( Hipot test)
Any measurement is performed by using the parameters stored in the active memory ( see MEMx
indication in the LCD screen right hand side )
Connect the measurement probe and the return lead on the specimen before starting the
measurement by pressing on the green MEASUREMENT push button.
To Next Page
Loading...