Eaton SV9000 - 7.19 Thermistor input of I;O-Expander; 7.20 Response to fieldbus fault

SV9000 Motor Pump Enhanced Protection Application Page 17 (60)
Group 12, Digital Output Parameters
Code Parameter Range Step Default Custom Description Page
12.1 Digital output function 0—22 1 1
0 = Not used
1 = Ready
2 = Run
3 = Fault
4 = Fault inverted
5 = SV9000 overheat warning
6 = External fault or warning
7 = Reference fault or warning
8 = Warning
9 = Reversed
10 = Jogging speed selected
11 = At speed
12 = Motor regulator activated
13 = Output freq. limit superv. 1
14 = Output freq. limit superv. 2
15 = Torque limit supervision
16 = Reference limit supervision
17 = External brake control
18 = Control from I/O terminals
19 = Frequency converter
temperature limit supervision
20 = Unrequested rotation direction
21 = External brake control inverted
22 = Thermistor fault or warning
50
12.2Relay output function0—2212Same as below (parameter 12. 3)50
12.3 Relay 2 output function 0—26 1 3
0 = Not used
1 = Ready
2 = Run
3 = Fault
4 = Fault inverted
5 = SV9000 overheat warning
6 = External fault or warning
7 = Reference fault or warning
8 = Warning
9 = Reversed
10 = Jogging speed selected
11 = At speed
12 = Motor regulator activated
13 = Output freq. limit superv. 1
14 = Output freq. limit superv. 2
15 = Torque limit supervision
16 = Reference limit supervision
17 = External brake control
18 = Control from I/O terminals
19 = Frequency converter
temperature limit supervision
20 = Unrequested rotation direction
21 = External brake control inverted
22 = Thermistor fault or warning
23 = Hot Motor Winding Fault
24 = Hot Motor Bearing Fault
25 = Seal Leak Detection Fault
26 = High Vibration Fault
50
12.4 Relay 3 output function 0—26 1 0 Same as above (parameter 12. 3) 50
Update Note:
2
Update Note:
3
12.5 Relay 4 output function 0—26 1 0 Same as above (parameter 12. 3) 50
12.6 Relay 5 output function 0—26 1 0 Same as above (parameter 12. 3) 50
12.7
Digital output DO1
on delay
0—600.0 s 0.1 s 0 0 = delay not in use 51
12.8
Digital output DO1
off delay
0—600.0 s 0.1 s 0 0 = delay not in use 51
12.9
Relay output RO1
on delay
0—600.0 s 0.1 s 0 0 = delay not in use 51
12.10
Relay output RO1
off delay
0—600.0 s 0.1 s 0 0 = delay not in use 51
12.11
Relay output RO2
on delay
0—600.0 s0.1 s 2.0 0 = delay not in use51
2.02.0