Eaton SV9000 - 7.17 Underload time; 7.18 Phase supervision of the supply voltage

Page 16A (60) Motor Pump Enhanced Protection Application SV9000
Group 11, Digital Input Parameters
Code Parameter Range Step Default Custom Description Page
11.5
DIC1 function 0—15 10
0 = Not used
1 = Ext. fault, closing contact
2 = External fault, opening contact
3 = Run enable
4 = Acc./dec. time selection
5 = Reverse
6 = Jogging speed
7 = Fault reset
8 = Acc./dec. operation prohibit
9 = DC-braking command
10 = Multi-Step Speed Select 1
11 = Motorized pot. speed up
12 = Hot Motor Winding - Open Contact
13 = Hot Motor Bearing - Open Contact
14 = Seal Leak Detection - Closed Contact
15 = High Vibration - Closed Contact
48
s
s
s
s
11.7 Hot Motor Winding Delay 0 - 600.0 0.1 2.0 0 = Delay not in use 49
11.8 Hot Motor Bearing Delay 0-600.0 0.1 2.0 0 = Delay not in use 49
11.9
Seal Leak Detection
Delay
0-600.0 0.1 2.0 0 = Delay not in use 49
11.10 High Vibration Delay 0-600.0 0.1 2.0 0 = Delay not in use 49
11.
6
DIC2 function 0 – 15 10
0 = Run Enable Open
1 = Ext. fault, closing contact
2 = External fault, opening contact
3 = Run Enable, Close
4 = Acc./dec. time selection
5 = Reverse
6 = Jogging speed select
7 = Fault reset
8 = Acc./dec. operation prohibit
9 = DC-braking command
10 = Multi-Step Speed Select 2
11 = Motorized pot. speed down
12 = Hot Motor Detection -
Open Contact
13 = Hot Motor Bearing -
Open Contact
14 = Seal Leak Detection -
Closed Contact
15 = High Vibration - Closed Contact
48