SV9000 Motor Pump Enhanced Protection Application Page 49 (60)
11.4 DIB6 function (terminal 16)
Selections are the same as 11.3 except:
10: Motorized Pot. Down =
11: Internal Motor Speed Pot. Up, contact closed = Reference increases until
the contact is opened
12: Hot Motor Detection, NC contact =
13: Hot Motor Bearing Detection, NC contact =
14: Seal Leak Detection, NO contact =
15:
11.5DIC1 function (Refer to page 16)
Selections are the same as 11.1 except:
10: Multi-Step 1 contact closed = Selection 1 active (speed select 1)
High Vibration Detection, NO contact =
11.6 DIC2 function
0:
1:
2:
3:
4:
5:
6:
7:
8:
9:
Run Enable, Open
Ext. fault, closing contact
External fault, opening contact
Run Enable, Close
Acc./dec. time selection
Reverse
Jogging speed select
Fault reset
Acc./dec. operation prohibit
DC-braking command
Multi-Step Speed Select 2
Motorized pot. speed down
Hot Motor Detection - Open Contact
Hot Motor Bearing - Open Contact
Seal Leak Detection - Closed Contact
High Vibration - Closed Contact
11.7 Hot Motor Winding Delay
11.8 Hot Motor Bearing Delay
11.9 Seal Leak Detection Delay
11.10 High Vibration Delay
These parameters set the delay time before the fault is activated.
10:
11:
12:
13:
14:
15:
To Next Page
Loading...
