COOLY C35HD BLACKEN
33
www.eberg.eu
Switch the unit of temperature
When the appliance is standby, press the M button 20 seconds, then you can change the
unit of temperature.
For example:
Before change, in cool mode, the screen display like g1.
After change, in cool mode, the screen display like g2.
SELF-DIAGNOSIS
The appliance has a self diagnosis system to identify a number of malfunctions.
Error messages are displayed on the appliance display.
IF IS DISPLAYED WHAT SHOULD I DO?
LOW TEMPERATURE
(frost prevention)
The appliance is tted with a frost protection device
to avoid excessive formation of ice.
The appliance starts up again automatically when
the defrosting process is completed.
PROBE FAILURE
(sensor damaged)
If this is displayed, contact your local authorised
service centre.
FULL TANK
(safety tank full)
Empty the internal safety tank,
following the instructions in the
„End of season operations” paragraph
Fig. 1 Fig. 2
To Next Page
Loading...
