Ebyte E104-BT11 User Manual

Chengdu Ebyte Electronic Technology Co., Ltd E104-BT11 User Manual
Copyright ©2012–2020，Chengdu Ebyte Electronic Technology Co.,Ltd
15
5.4.1.5 Network whitelist configuration
Operation code
Parameter
Request
0x06
MAC address
Response
0x06
<quantity><MAC1><…>
For
example,
Request
08 C0 06 112233445566
Response
0F 40 06 02 112233445566 aabbccddeeff
Remark
1. This directive only applies to BT11-G;
2. The same MAC is added repeatedly, no error will be returned, and no new entries will be added.
3. Return to the opened serial number and added MAC.
4. Effective immediately, save after power off.
5.4.1.6 Network whitelist deletion
Operation code
Parameter
Request
0x07
Mac address
Response
0x07
<quantity><MAC1><…>
For example,
Request
08 C0 07 112233445566
Response
09 40 07 01 aabbccddeeff
Remark
1. This directive only applies to BT11-G;
2. Deleting a non-existent MAC address will not cause an error;
3. Return all remaining MAC addresses;
4. Effective immediately, save after power off.
5.4.1.7 Network whitelist read
Operation code
Parameter
Request
0x08
N/A
Response
0x08
<quantity><MAC1><…>
For example,
Request
02 C0 08
Response
0F 40 08 02 112233445566 aabbccddeeff
Remark
1. This directive only applies to BT11-G;
2. Return to the opened serial number and MAC.
5.4.1.8 Device network access
There are two ways to use the device network access instruction. The method with parameters is used to specify the enabling of
the node function, and the method with N/A parameters is disabled by default.

Ebyte E104-BT11 Specifications

General

Brand	Ebyte
Model	E104-BT11
Category	Control Unit
Language	English