Page 11 of 20
Emergency Mode Flash Pattern Selection – Synchronized
The seven customizable emergency ash pattern modes each have the option to be synchronized. This condenses the module groups
from Table to front and rear. The default ash sequences are shown below in Table 7.
Module Group Wires - Synchronized
Function Wire Color Module Sequence Group
GRN/WHT Front
BLU/BLK Rear
TABLE 8
Level Mode Default Sequence by Group - Synchronized
Module Group L1 L2 L3
Front Off Left/Right Cycle
Rear Left/Right Off Cycle
L1 + L2 L1 + L3 L2 + L3 L1 + L2 + L3
Front Left/Right Left/Right Left/Right Left/Right
Rear Left/Right Left/Right Left/Right Left/Right
TABLE 7
To toggle synchronized groups on or off
1. Power-up the Lightbar and apply +power to a single level mode (see Table 2) in the 16 conductor cable.
2. Momentarily touch the BLK/RED Pattern wire and the RED wire to +power to set the level mode to synchronized. The four corner modules
will turn on each time the lightbar is toggled between unsynchronized and synchronized.
Module Group Flash Sequence - Synchronized
Order Sequence LED Module Colors
1 Off Both
2 Left/Right Primary Only Primary Only
3 Even/Odd Primary Only Primary Only
4 Left/Right Secondary Only Secondary Only
5 Even/Odd Secondary Only Secondary Only
6 Left/Right Multi-Color Both
7 Even/Odd Multi-Color Both
8 Left/Right Primary with Secondary Pop
9 Even/Odd Primary with Secondary Pop
10 Left/Right Primary with Secondary Random
11 Even/Odd Primary with Secondary Random
12 Cycle Both
13 All On Multi-Color Both
14 Left/Right Primary Primary with Secondary Random
TABLE 9
To change a Module group ash sequence selection:
1. Power-up the lightbar and apply +power to a single level mode (see Table 2) in the 16 conductor cable.
2. Momentarily touch the BLK/RED pattern select wire and the appropriate Module group wire, shown in Table 8, to +power to cycle through
the sequences shown in shown in Table 9.
To Next Page
Loading...
