Ecco 21 Series - Arrowstik Flash Pattern Selection; Arrowstik End Flash Pattern Selection

Page 13 of 20
Arrowstik Flash Pattern Selection
The CC Series Lightbar is designed to offer user selectable trafc directing and trafc warning ash patterns. Each of the ArrowStik® func-
tions (LEFT, CENTER-OUT, RIGHT or FLASH) can be programmed individually for unique sequences and ash rates. This allows the great-
est exibility when controlling the various lightbar congurations available. The lightbar can be congured with 5, 6, 7 or 8 Module modules
and comes from the factory with the Building Fast pattern as the default for LEFT, CENTER-OUT and RIGHT. The default pattern for FLASH
is Driver’s Side Cut – front, corner & alley.
Arrowsik Left, Center-Out &
Right Flash Patterns
Order Flash Pattern
1 Building*
2 Building, 3-Flash*
3 Traveling Ball, 3-Flash*
4 Build/Collapse*
TABLE 13
Arrowstik Flash Patterns
Order Flash Pattern
1 Drivers Side Cut - Front corner & alley
2 Drivers Side Cut - Rear corner & alley
3 Drivers Side Cut - Front outboard, corner alley
4 Standard Flash*
5 Quad Flash Standard
6 Simultaneous Flash*
7 Quad Flash Simultaneous
8 Even/Odd Flash*
9 Quad Flash Even/Odd
10 Left/Right Flash*
11 Quad Flash Left/Right
12 Travelling Ball Flash*
TABLE 14
Arrowstik End Flash Pattern Selection
The lightbar can be ordered with two additional lamps positioned at the outermost ends of the ArrowStik. These two modules may be cong-
ured for the End Flash function during ArrowStik operation. The factory default is the off sequence.
Arrowstik End Flash Patterns
Order Multicolor Modules Single Color Modules
1 Off Off
2 Alternating - Both Alternating
3 Alternating - Primary Only
4 Alternating - Secondary
Only
TABLE 15
To select a ash pattern for one of the four Arrowstik functions,
1. Power-up the lightbar and apply +power to a single Arrowstik mode (see Table 41) in the 16 conductor cable.
2. Momentarily touch the Pattern Select wire (BLK/RED) to +power to cycle through the ash patterns shown in Tables 13 and 14 below. Hold
for more than 4 seconds to return to the factory default.
Flash patterns marked with an asterisk (*) can be selected in Fast, Medium or Slow ash rate.
To congure Arrowstik End Flash:
1. Power-up the lightbar and apply +power to a single ArrowStik function - LEFT (RED), CENTEROUT (RED + ORG), RIGHT (ORG) or
FLASH (WHT).
2. Momentarily hold the BLK/RED and BLK wires to +power to increment to the next end ash sequence shown in Table 15. Hold for more
than 4 seconds to return to the factory default setting.