Ecco 21 Series - Multicolor Module LED Color Hierarchy; To Change a Module Group Flash Pattern Selection; Module Group Wires - Unsynchronized

Page 9 of 20
**For AMBER/WHITE modules within the Arrowstik, WHITE is primary and AMBER is secondary.
To change a Module group ash pattern selection:
1. Power-up the lightbar and apply +power to a single level mode (see Table 2). The lightbar will ash the default pattern shown in Table 3.
2. Twist together the BLK/RED Pattern select wire in the 16 conductor cable and the wire of the Module group you want to change shown in
Table 5.
3. Momentarily touch the BLK/RED and group wire from step 2 to power to cycle through one pattern as detailed in Table 6. The pattern for
the module group congured will only be set in the level mode selected. Hold the wires to power for more than 4 seconds to return to the
default ash pattern.
TABLE 4
Module Group Wires - Unsynchronized
Function Wire Color Module Group
GRN/WHT Front Outboard
BLU/BLK Front Inboard
GRN Front Corner
BLK/WHT Rear Outboard
RED/WHT Rear Inboard
BLU/WHT Rear Center
BLU Rear Corner
BLK Rear End
ORG/BLK Takedown/Work Lights
WHT Alley
TABLE 5
Multicolor Module LED Color Hierarchy
Color Combination Primary Secondary
RED/BLUE RED BLUE
RED/AMBER RED AMBER
RED/WHITE RED WHITE
BLUE/AMBER BLUE AMBER
BLUE/WHITE BLUE WHITE
AMBER/WHITE** AMBER WHITE