Page 19 of 20
Troubleshooting:
All lightbars are thoroughly tested prior to shipment. However, should you encounter a problem during installation or during the life of the product, follow the
guide below for troubleshooting and repair information. If the problem cannot be rectied using the solutions given below, additional information may be
obtained from the manufacturer – contact details are at the end of this document.
PROBLEM POSSIBLE CAUSE SOLUTION
Does not function Poor power or ground connection In CC Lightbars, a green light on the central
control board should ash when power is
rst applied to the bar and during ash pat-
tern selection.
Blown fuse Check wiring, replace fuse
Incorrect ash patterns Wrong ash conguration Cycle through ash patterns according to
the supplied wire key and wiring instruc-
tions section of this installation guide.
NOTE: Operating the vehicle without the outer lens installed on the product may result in damage that will NOT be
covered under the warranty.
To Next Page
Loading...
