ECG ESP 20301 - Before First Time Use; Cleaning the Nozzle

English English
11
1) Before rst time use.
1. Put
the lever with filter WITHOUT COFFEE in the machine under the symbol „INSERT“ so that the tabs
on the metal cup fit in the sfunnel Secure everything by turning the lever counterclockwise in the „LOCK“
position.
2. Place a cup on the grid under the metal cup. Make sure the rotary knob is in the neutral position.
3. Connect the appliance to the power supply and switch it on with the ON / OFF switch. The red
operation indicator lights up. When the white light is on continuously, the machine is preheated. You can
start using it.
4. Turn the knob to the "coffee" position and let hot water flow out of the holder for approx. 30 seconds.
Note:
The unit may be more noisy due to water being sucked into the system for about the rst 20 seconds.
Note: Use the same procedure for preheating the coee.
Cleaning the nozzle.
Warning: During the formation of hot water or steam, the lever with lter must be always placed in the
brew head.
1. Press the ON/OFF switch, the operation indicator (red) comes on and the machines preheats (the white
indicator is on continuously).
2. Place a suitably deep water container under the nozzle to catch the steam. The nozzle should suciently
immersed in the container. Carefully, the steam is hot.
3. Turn the knob to the "steam" position and let the steam ow into the water container for about 1 minute.
Then turn the knob into neutral position.
The coee maker machine is ready to be used.
2) NORMAL USE PROCEDURE.
Check, if there is water in the water tank before each use. Do not exceed the "MAX" line.
Preheat
To make a cup of good hot Espresso coee, we recommend preheating the appliance, including the holder,
lter and cup, so that the taste of the coee is not aected by the cold parts.
1. Put
the lever with filter WITHOUT COFFEE in the machine under the symbol „INSERT“ so that the tabs
on the metal cup fit in the funnel. Secure everything by turning the lever counterclockwise in the „LOCK“
position.
2. Place a cup on the grid under the metal cup. Make sure the rotary knob is in the neutral position.