What to do if there is no spark at the plug in my Echo Pole Saw?
If there is no spark at the plug of your Echo Pole Saw, there are several things to check: * Ensure the spark gap is correctly adjusted to 0.65 mm (0.026 in.). * If the spark plug is covered with carbon or fouled with fuel, clean or replace it. * Also, the spark plug itself may be defective and need replacement.
Why is there no spark at the end of the plug wire on my Echo Pole Saw?
If there is no spark at the end of the plug wire on your Echo Pole Saw, first ensure the stop switch is turned on. If the issue persists, it could indicate an electrical problem or an interlock switch issue, and you should consult your Echo dealer.
Why does my Echo 001001 - 504999 Pole Saw engine run, then die or accelerate poorly?
If your Echo Pole Saw engine runs, but dies or accelerates poorly, several factors could be at play. First, check the air filter and clean or replace it if it's dirty. A dirty fuel filter can also cause this issue, so replace it. Additionally, a plugged fuel vent can be the culprit, requiring replacement. Inspect the spark plug; clean and adjust it, or replace it if necessary. Other potential causes include carburetor issues that require adjustment, a plugged cooling system that needs cleaning, or a plugged exhaust port/spark arrestor screen, which should also be cleaned.
What to do if the muffler on my Echo Pole Saw is wet with fuel?
If the muffler of your Echo Pole Saw is wet with fuel, it indicates that the fuel mixture is too rich. To resolve this, try opening the choke. You can also clean or replace the air filter. If these steps don't work, the carburetor may need adjustment, or you may need to consult your Echo dealer.
General| Bar Length | 8 inches |
|---|---|
| Oil Capacity | 6.7 oz |
| Fuel Capacity | 16.9 oz |
| Power Source | Gasoline |
| Guide Bar Length | 8 in |
| Chain Pitch | 3/8 in |
| Chain Gauge | 0.050 in |
| Fuel Tank Capacity | 16.9 fl oz |
| Oil Tank Capacity | 6.7 fl oz |
To Next Page