26
GUIDE BAR AND SAW CHAIN REPLACEMENT
WARNING DANGER
Never try to replace or adjust guide bar and saw chain with engine running. This saw chain is VERY sharp, wear
heavy gloves to protect your hands when handling it. Wear eye protection meeting ANSI specification Z87.1.
Guide Bar Replacement / Installation
Level 3
• Loosen two (2) 11mm (7/16") bar bolts (A) and relieve saw chain
tension turning screw (B) counter clockwise.
• Remove screw (C) and sprocket cover.
• Free saw chain from sprocket and remove from guide bar. If guide
bar is okay proceed to saw chain installation.
• Slide guide bar forward and remove from cutting attachment.
Install new guide bar sliding it onto the cutting attachment as far
as possible.
Saw Chain Installation
Level 3
• Install new saw chain onto guide bar. Make sure cutting links are
faced towards the nose of the bar.
• Engage saw chain with sprocket.
• Replace sprocket cover.
• Follow instruction on adjusting saw chain tension page 14.
A
B
C
To Next Page
Loading...
Need help?
General