Echo 02999999 - Balancing and Blade Operation Preparation; Unit Balancing Procedure; Preparing for Blade Operation

GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
21
P
18. Balance unit.
a. Loosen harness hook (P).
b. Put on harness and attach unit to harness.
c. Slide harness hook (P) up or down until unit balances with
cutting attachment approximately 2 - 3" from ground.
d. Tighten harness hook screw.
PRE - OPERATION
OPERATION
WITH BLADES
Preparing the Trimmer/Brush Cutter for Blade Use
WARNING DANGER
Blade use DEMANDS specific Brush Cutter configuration. Operation without specified shield and harness can result
in serious personal injury.
Plastic and Nylon Blades Require "Blade Conversion Kit," P/N 99944200415
(Metal Shield [A] and Shoulder Harness [B]).
A
B