16
Before you start
Before yo u start
Assembly
Stand assembly
Fasten the stand to the operation shaft.
Operation shaft assembly
Stand the engine upright on a level surface.
Fit the operation shaft ensuring that it is correctly engaged.
Tighten bolts (M5×25) to fasten the operation shaft.
U-handle assembly
Install the left handle in the handle support and fix it by lightly
tightening bolts (M5×35) .
Adjust inclination of handle to adequate position (easy to op-
erate) and firmly tighten bolts (M5×35).
WARNING
Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
1. Operation shaft
2. Stand
3. Bolt M5×20
1. Bolt M5×25
1. Handle support
2. Adjustable
3. Left handle
4. Bolt M5×35
To Next Page
Loading...
