Echo BEARCAT sc3206 - Machine Operation; Starting Procedures

10 3 INCH CHIPPER/SHREDDER
Section
OPERATION
       
      
       


WARNING
4 4
4.2 STARTING ELECTRIC MODELS
4.1 STARTING RECOIL MODELS


        

CHIPPING OPERATION
         
      

chipper chute is sliced into small chips and propelled out
through a discharge tube.



WARNING
       
           
60 second cool down period between starting attempts.
        

       

engine rotation must be allowed to come to a complete




        


machine.
1.
       2.

choke position.
3.
the switch as soon as the engine starts.
4.
5.
the chipper/shredder.
For a Cold Engine — 6.    
control to the off 
warms up. 
         
        
For a Warm Engine — Return choke to the off position
as soon as engine starts.
1.
       2.

Place the choke control into the choke position.3.
4.
Pull the recoil starter until the engine starts. Make sure 5.
the starting cord retracts.
6.
7.
the chipper/shredder.
SHREDDING OPERATION


        
discharge screen. The shredded material can be diverted
into a container or onto the ground.
For a Cold Engine —    
control to the off 



For a Warm Engine — Return choke to the off position
as soon as engine starts.