IGNITION SYSTEM
CS-271T
21
3-10 Inspecting ywheel and key (continued)
6. Remove starter pawls. Then set puller
89750103938 (C) on ywheel as shown.
7. Tighten two nuts on the puller alternately to re-
move ywheel.
8. Inspect woodruff key for damage or shearing.
Replace as required.
9. Wipe off oil from taper part of crankshaft and y-
wheel before assembling ywheel.
10. Install woodruff key into key groove.
11. Reinstall starter pawls (Refer to “2-4 Replacing
starter pawl”).
12. Align ywheel key groove with woodruff key on
crankshaft. Install ywheel and fasten ywheel nut
clockwise.
C
To Next Page
Loading...
