SAW CHAIN LUBRICATION SYSTEM
CS-271T
45
7-3 Inspectingoilline
1. Remove sprocket guard.
2. Remove screw (A) and remove chain catcher (B)
and sprocket guard plate (C).
3. Disconnect oil line (D) and clip from auto-oiler
assembly.
4. Connect pressure tester 89780330133 (E) to oil
line (D).
NOTE: To connect pressure tester to oil line, it is
recommended to use pipe joint V186000020 (F).
5. Tighten oil cap and apply pressure approx. 9.8
kPa (0.1kgf/cm
2
) (1.4psi).
6. Pressure should not drop. If the pressure drops,
leakage may occur at oil cap, oil cap O-ring, oil
line, grommet, oil tank vent, or oil tank. Inspect
them and replace defective part(s) with new parts
as required.
B
E
A
C
F
D
F
To Next Page
Loading...
