Echo CS-271T - Page 51

SAW CHAIN LUBRICATION SYSTEM
CS-271T
49
7-7 Assemblingauto-oilerparts
1. Assemble spring (A) to plunger (B) as shown.
2. Coat plunger gear (b) and spring (A) with grease
and insert into cylinder (C) of auto-oiler body.
NOTE: Do not apply grease on V-ring (D) and
plunger shaft end (E), because these are a part of
chain oil passage.
3. Push in plunger with small screwdriver (F), and
hold plunger in place with nger through the center
hole (G) of auto-oiler body. Remove screwdriver
(F).
4. Install adjuster needle (H) with spring (J) into oil-
er body.
5. Press adjuster needle (H) to the bottom, orient-
ing the at surface (h) as shown.
6. Tap in new spring pin (K) into hole (L) of adjuster
needle, until spring pin bottoms.
7. Apply grease in plunger hole. Tap plug (M) into
hole with plastic mallet until plug is ush with the
outer hole wall circumference.
F
E
D
B
A
G
C
H
b
J
K
L
H
h
h
M