ENGINE
CS-271T
54
8-5 Removingengineblock
1. Remove sprocket guard, clutch assembly and
auto-oiler assembly (Refer to “5-1 Inspecting clutch
parts”).
2. Remove air cleaner cover, air filter case and
carburetor.
3. Remove ywheel (Refer to “3-10 Inspecting y-
wheel and key”).
4. Remove ignition coil (Refer to “3-8 Replacing
ignition coil”).
5. Remove muffler and heat shield with muffler
gasket (Refer to “8-3 Inspecting muffler and ex-
haust port”).
6. Remove front handle and top handle.
7. Remove dust cover and remove two bolts (A).
8. Remove intake bellows (B).
9. Remove two bolts (C) from bottom of the unit.
10. Pull out engine block from engine cover.
C
A
B
To Next Page
Loading...
