Echo CS-271T - Page 59

ENGINE
CS-271T
57
8-10Replacingneedlebearing
NOTE: Always use needle bearing tool
89770511520 to replace needle bearing on small
end of connecting rod.
1. Put small end on base (A) of needle bearing tool
and t needle bearing (B) in hole (a) of the base.
2. Push needle bearing out from small end using
the smaller pusher (C).
3. Put small end of connecting rod on the base
aligning both holes of small end and the base.
4. Put a new needle bearing on small end.
NOTE: The side stamped with identication of nee-
dle bearing should face up.
5. Push needle bearing into the bottom using the
larger pusher (D).
1K235
1K236
D
B
A
C
a
20mm (0.8in)
8mm (0.3in)
12mm (0.5in)
8mm (0.3in)