CS-303T OPERATION
X7503209108 37
© 10/20 ECHO Incorporated
3. Squeeze throttle trigger
gradually and increase engine
speed.
4. The chain starts running when
the engine reaches clutch
engagement speed (see
technical data page).
5. Confirm proper acceleration
and lubrication of chain and
bar.
6. Do not run the engine at high
speed unnecessarily.
7. Be sure that saw chain stops
moving when throttle trigger is
released.
Stopping
1. Release Throttle Trigger (F)
and allow engine to idle.
2. Move Stop Switch (A)
REARWARD to “STOP”
position.
Note: If engine does not stop,
pull Choke Control Knob
(C)
A
all the way out (CLOSED
[ ] choke position).
Return the unit to your
authorized dealer to check and repair stop switch before
starting the engine again.
To Next Page
Loading...
