CS-310 OPERATION
X7503275401 31
© 02/2019 ECHO Inc.
8. Push choke control knob all the
way IN (OPEN choke
position).
9. Pull starter handle to start the
engine.
Note: Do not pull starter rope out
to the maximum possible
position.
Note: Do not allow recoil handle
to snap back against the
casing.
Note: If engine does not start
after 5 pulls, repeat instructions.
◆ After starting the engine, immediately squeeze and then
release throttle trigger to release fast idle throttle latch,
otherwise severe brake damage may occur.
◆ Never use fast idle throttle latch for cutting.
◆ Use the fast idle throttle latch only in starting.
Note: Do not increase engine speed while chain brake is locked.
Severe brake damage will result.
Starting Warm Engine
Make sure the bar and chain are free from any obstruction when
starting the chain saw.
To Next Page
Loading...
Need help?
General
