OPERATION CS-4510
34 X7503350603
© 06/2019 ECHO Incorporated.
◆ Do not let the tip of the bar
touch anything while the
engine is running. At
cutting speed the chain is
moving at a high rate of
speed. Should the tip
contact a limb or log while
the chain is moving, the tip
will be pushed upward with
considerable force. This is known as kickback. Avoid it!
In all circumstances the operation of the chain saw is a one-man job. It is
difficult at times to take care for your own safety, so don’t assume the
responsibility for a helper as well. After you have learned the basic
techniques of using the saw, your best aid will be your own good common
sense.
The accepted way to hold the saw is
to stand to the left of the saw with
your left hand on the front handlebar
and your right hand on the rear
handle so you can operate the throttle
trigger with your right index finger.
Before attempting to fell a tree, cut
some small logs or limbs. Become
thoroughly familiar with the controls
and the responses of the saw.
Start the engine, see that it is running
properly. Squeeze the trigger to open
the throttle wide open and start the
cut. If the chain is properly
sharpened, the cutting should be
relatively effortless. It is not
necessary to press down hard to
make the saw cut. Pushing the saw
too hard will slow the engine and
cutting will actually be more difficult.
Sap from palm trees may corrode metal parts unless proper saw
maintenance is performed. Make sure to clean metal parts from palm
sap immediately after use.
Shown with optional
Kick Guard
TM
Shown with optional
Kick Guard
TM
To Next Page
Loading...
Need help?
General
