22
Maintenance and care
Maintenance and care
Servicing guidelines
Maintenance and care
Cleaning battery and battery compartment
1. Release trigger switch and trigger switch lockout and allow
trimmer head to stop.
2. Make sure power indicator LED is not illuminated.
3. Depress battery pack latch release (A) slide battery pack out
of power head.
4. Use compressed air or a soft bristle brush to remove debris
from battery and battery compartment.
Angle transmission
1. Remove the plug (A) and drain screw (B) from the angle
transmission (C).
2. Add grease into the transmission until old grease is pushed
out. If necessary, use a low pressure pump.
3. Reinstall the drain screw and plug.
WARNING
Observe the following precautions when checking and maintaining your product after use:
Turn power to unit off, remove battery, and make sure all moving parts have come to a complete stop.
An accident could occur if the product starts unexpectedly.
Allow unit to cool before performing service.
You could burn yourself.
Never service damaged battery packs. Service of battery packs should only be performed by the manufacturer or
authorized service providers.
IMPORTANT
Checking and maintenance requires specialist knowledge. If you are unable to check and maintain the product or deal with a
fault yourself, consult your dealer. Do not attempt to dismantle the product.
Area Maintenance Page Before use Monthly
Battery Inspect/Clean/Charge 10 •
Angle transmission Grease 22 •*
Cut off knife Inspect/Clean - •
Screws, bolts and nuts Inspect, Tighten/Replace - •
* Or 50 hours, whichever occurs first.
If you have any questions or problems, please contact your dealer.
WARNING
Risk of electric shock or fire. Do not use conducting ma-
terials to clean battery or battery compartment.
NOTE
Use good quality lithium multi grease.
To Next Page
Loading...
Need help?
General
