Echo Grass Trimmer/Brush Cutter SRM-280 - Lubrication; Gear Housing Lubrication; Drive Shaft Lubrication

24
l u b r I c a t I o n
Level 1.
Tools Required: 8 & 13mm Open End Wrenches, Screwdriver, Clean
Rag, Grease Gun
Parts Required: POWER BLENDX
TM
8 oz. (P/N 91014) or Lithium
Base Grease.
Gear Housing
1. Clean all loose debris from gear box.
2. Remove plug (A) and check level of grease. Grease should ll gear
case to bottom of grease plug hole.
3. Add grease if necessary using manual grease gun or squeeze-type
tube. Do not use high pressure grease gun. DO NOT over-ll.
Drive Shaft
(SRM-280 Only)
1. Loosen two (2) screws (B) and remove center locating screw (C).
Pull gear box and shield from drive shaft housing.
2. Pull exible cable from the drive shaft housing, wipe clean and
re-coat with a thin coating [15 ml (1/2 oz.)] of grease.
3. Slide the exible cable back in the drive housing. DO NOT get
dirt on the ex cable.
4. Install the gear housing and shield assembly.
IMPORTANT
Flat edge of washers (D) must be against drive shaft.
(SRM-280S Only)
No Lubrication Needed.
B
C
B
D
A
A