Pr o At t A c h m e n t Se r i e S
tm
oP e r A t o r 'S mA n u A l
29
I
G
B
H
6. Feed ends of line through housing eyelets (G) and place spool (B)
over drive (H). Align pegs (I) on drive with notches in spool, and
push spool into drum.
7. Pull on both lines until they come free from notches (F) in spool.
8. Hold drum (A) rmly and turn spool (B) CCW (counterclockwise)
until it stops. DO NOT push in on spool when turning.
9. Pull both lines out and trim to cut-off knife length.
B
A
To Next Page
Loading...
