PAS-230 OPERATION
© 04/2013 ECHO Inc.
X7532098805 17
Note: If attachment moves, readjust carburetor according to “Carburetor Adjustment” instructions in this
manual or see your ECHO Dealer.
1. Stop Switch
Move stop switch button (A) forward away from the STOP
position.
2. Purge Bulb
Pump purge bulb (C) until fuel is visible in the “Clear” fuel
return line.
3. Recoil Starter
Lay the unit on a flat area and keep movable attachment parts
clear of all obstacles. Rapidly pull the recoil starter handle (D)
until the engine fires.
Note: If engine does not start after 5 pulls, use Cold Start
Procedure.
Stopping Engine
1. Throttle
Release throttle and allow engine to return to idle before
shutting off engine.
2. Stop Switch
Move stop switch button (A) backward to STOP position.
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall
engine. Have your ECHO dealer repair stop switch before using unit again.
To Next Page
Loading...
